![]() |
Benvenuto Visitatore ( Log In | Registrati )
![]() |
![]()
Messaggio
#1
|
|
Special User ![]() Gruppo: Banned Messaggi: 168 Iscritto il: Sat 29 January 2005 - 00:54 Utente Nr.: 3.802 Feedback: 1 (100%) ![]() |
VI PREGO AIUTATEMI !
Tentando di flashare il DS lite di un amico si e' interrotto all' 1% e ora non si accende +,era la prima volta che provevamo a flasharlo come mi posso comportare vi prego snocciolate qqalsiasi idea per recuperarlo altrimenti dovro' sborsare 159€ ! ![]() ![]() ![]() Vi prego A I U T O ! ![]() ![]() ![]() ![]() |
|
|
![]() |
![]()
Messaggio
#2
|
|
![]() Utente GBARL ![]() Gruppo: Membri Messaggi: 38 Iscritto il: Sun 7 January 2007 - 23:27 Utente Nr.: 15.929 Feedback: 0 (0%) ![]() |
Da wikipedia:
<<This new passthrough method is not without risks, however. In order to successfully overwrite the firmware, the write-enable contacts (SL1) need to be short circuited to allow writing to the first 512 bytes of the firmware. The SL1 contacts are located next to the battery under the square red and white sticker on the original Nintendo DS, and on the very left of the holes on the DS Lite. Removing the sticker on the original DS voids the warranty. The flashing process is halted if the SL1 contact is no longer short-circuited. If the power is turned off before the first 2% of the flashing process, the Nintendo DS will fail to run and is most likely non recoverable unless the first block (100 bytes) has been written (see lower right hand corner of the screen when flashing). If the DS loses power during the process and enough of the firmware was flashed, holding the Start, Select, A, and B buttons will boot FlashMe from a GBA cart in a failsafe mode.>> Prova, magari prima di spegnersi è passato al 2%... -------------------- Paul
Xbox 360 Pro / Wii / NDS lite / XBox / Psx / Gameboy (in ordine cronologico XD) |
|
|
![]() ![]() |
![]() |
Versione Lo-Fi | Oggi è il: Wed 9 July 2025- 23:59 |